A30M Archieven - Jantec.nl https://jantecnl.synology.me/en/category/3d-printing/a30m/ 3D modeling, scanning and printing Fri, 05 Aug 2022 10:19:00 +0000 en-US hourly 1 https://wordpress.org/?v=7.0 https://jantecnl.synology.me/wp-content/uploads/2026/03/cropped-pagina01d-32x32.jpg A30M Archieven - Jantec.nl https://jantecnl.synology.me/en/category/3d-printing/a30m/ 32 32 Printing at maximum width on my Geeetech A30M with PETG and the Duet2wifi board https://jantecnl.synology.me/en/printing-at-maximum-width-on-my-geeetech-a30m-with-petg-and-the-duet2wifi-board/ Sat, 20 Nov 2021 12:50:32 +0000 https://jantecnl.synology.me/?p=9060 Yesterday I exchanged the dual nozzle printerhead (Chimera) that I have been using for dual printing all kinds of goodies like my name tag and several dual color prints, with the original single nozzle-dual extruder head. I needed to print a LED lights circular holder that is 328mm wide, and the setrup with the Chimera …

Continue reading "Printing at maximum width on my Geeetech A30M with PETG and the Duet2wifi board"

Het bericht Printing at maximum width on my Geeetech A30M with PETG and the Duet2wifi board verscheen eerst op Jantec.nl.

]]> Triple mixing hotend for A30M https://jantecnl.synology.me/en/triple-mixing-hotend-for-a30m/ Wed, 30 Jun 2021 07:23:38 +0000 https://jangriffioen.com/?p=4053 Next to the penta non-mixing hotend, I recently bought this mixing triple hotend, to experiment with it on the A30M.  It is not the same as the Geeetech original triple mixing hotend, however it does have some resemblance. Obviously, this hotend requires 3 extruders via bowden tubes.  The extruders I have are all Chinese clones …

Continue reading "Triple mixing hotend for A30M"

Het bericht Triple mixing hotend for A30M verscheen eerst op Jantec.nl.

]]> Penta extruder on A30M https://jantecnl.synology.me/en/quad-extruder-on-a30m/ Sat, 24 Apr 2021 14:07:53 +0000 https://jangriffioen.com/?p=3093 Today I received my 5-in, 1-out hotend, non-mixing  air cooled with 1 nozzle and 1 heater//temp sensor. I will install it on my A30M with the Duet2wifi board+extension board (5-fold with plug-in drivers). The A30M already has independant Z-stepper motors. The Duet2wifi has 5 stepper ports, and the expansion board also has 5 stepper ports.  …

Continue reading "Penta extruder on A30M"

Het bericht Penta extruder on A30M verscheen eerst op Jantec.nl.

]]>