Multicolour Archieven - Jantec.nl https://jantecnl.synology.me/en/category/multicolour/ 3D modeling, scanning and printing Thu, 11 Sep 2025 21:08:18 +0000 en-US hourly 1 https://wordpress.org/?v=7.0 https://jantecnl.synology.me/wp-content/uploads/2026/03/cropped-pagina01d-32x32.jpg Multicolour Archieven - Jantec.nl https://jantecnl.synology.me/en/category/multicolour/ 32 32 E3D toolchanger 4xHemera direct drive first 4-color PLA benchy & 3D-world https://jantecnl.synology.me/en/e3d-toolchanger-4xhemera-direct-drive-first-4-color-pla-benchy/ Thu, 06 Oct 2022 07:52:57 +0000 https://jantecnl.synology.me/?p=11677 The bow of the benchy , the white right part at the bottom sags a bit. The solution was to set the bed temperature at 10 degrees lower. So;  I now start with 60 degrees and after the first layer the bed temp goes to 50 degrees. In addition, I flipped the benchy 180 degrees …

Continue reading "E3D toolchanger 4xHemera direct drive first 4-color PLA benchy & 3D-world"

Het bericht E3D toolchanger 4xHemera direct drive first 4-color PLA benchy & 3D-world verscheen eerst op Jantec.nl.

]]> MMU2S on Ender3pro with TT SKR E3 mini motherboard https://jantecnl.synology.me/en/mmu2s-on-ender3pro-with-skr-e3-mini-motherboard/ Wed, 05 May 2021 15:36:28 +0000 https://jangriffioen.com/?p=3143 In 2020 I upgraded my Ender 3 with synchronised Z-axes and a new motherboard, the SKR Mini E3 V2.1. The Ender 3 is very reliable and has been equipped with a direct drive bondtech extruder but still has the original hotend. I chose the Ender3 to be the 3d printer on which I will attach …

Continue reading "MMU2S on Ender3pro with TT SKR E3 mini motherboard"

Het bericht MMU2S on Ender3pro with TT SKR E3 mini motherboard verscheen eerst op Jantec.nl.

]]>