Prusa I3-2 carriages Archieven - Jantec.nl https://jantecnl.synology.me/en/category/3d-printing/prusa-i3-dual-carriage/ 3D modeling, scanning and printing Sat, 01 Mar 2025 10:20:04 +0000 en-US hourly 1 https://wordpress.org/?v=7.0 https://jantecnl.synology.me/wp-content/uploads/2026/03/cropped-pagina01d-32x32.jpg Prusa I3-2 carriages Archieven - Jantec.nl https://jantecnl.synology.me/en/category/3d-printing/prusa-i3-dual-carriage/ 32 32 Dual magnetic parking extruders I3 Bear Duet2wifi build and Config files https://jantecnl.synology.me/en/dual-magnetic-parking-extruders-i3-bear-duet2wifi-build-and-config-files/ Sun, 09 Apr 2023 08:37:37 +0000 https://jangriffioen.com/?p=2954 My dual carriage I3-bear based 3d printer is working very well. On this page I share my latest configuration files, my build experiences like the used STL’s , schematics and so on.  Hope you enjoy! Be aware that the tool settings in config.g are set including relative X, Y, Z values for this build so …

Continue reading "Dual magnetic parking extruders I3 Bear Duet2wifi build and Config files"

Het bericht Dual magnetic parking extruders I3 Bear Duet2wifi build and Config files verscheen eerst op Jantec.nl.

]]> Hanging 3d printer https://jantecnl.synology.me/en/hanging-3d-printer/ Sun, 30 May 2021 14:09:57 +0000 https://jangriffioen.com/?p=3985 My last 3d printer I built just produced too much noise, mainly from changing the tools during multi-filament prints Finally, I made a construction where the printer hangs in big elastic suspenders.  This took away any noise that was previously transferred to the wall, so no more problems with noises throughout the house.  Pfff…

Het bericht Hanging 3d printer verscheen eerst op Jantec.nl.

]]> Magnetic dual parking extruders reprap I3 Bear with Duet2wifi and sensorless homing https://jantecnl.synology.me/en/magnetic-dual-parking-extruders-reprap-i3-bear-with-duet2wifi-and-sensorless-homing/ Fri, 02 Apr 2021 09:21:49 +0000 https://jantecnl.synology.me/?p=2749 My most recent and probably last build from scratch is the dual carriage I3-based printer as shown in the below picture, in the building phase.  This printer can be used either for 2 colors or for printing with soluble support PVA filament. I decided to use sensorless homing for this build due to problems when …

Continue reading "Magnetic dual parking extruders reprap I3 Bear with Duet2wifi and sensorless homing"

Het bericht Magnetic dual parking extruders reprap I3 Bear with Duet2wifi and sensorless homing verscheen eerst op Jantec.nl.

]]>